CYCLONE ELRS 2.4G 915MHz Nano/EP1/EP2 2400 RX receiver

The CYCLONE receiver series is an open source architecture and program based on ExpressLRS, and we have released 3 types of RX receiver modules. Both use the ESP8285 MCU. You can upgrade the firmware over WIFI, which is very friendly. Usually, after you power the receiver, the remote control is off, and the hotspot of ExpressLRS can be found in the default 60s. You can connect to the hotspot through your computer or mobile phone, the password is expresslrs, and then you can access 10.0.0.1 to upload the firmware of the receiver.
Nano 2400RX receiver with power amplifier (PA+LNA). As a result, it has a 100mW telemetry output and better sensitivity over longer distances, with an IPEX1 antenna base, coupled with an external dipole T-antenna (custom-made by a professional factory, each antenna is tested by a professional instrument). There is no PA/LNA on the EP12400RX receiver, so its telemetry power is the same as that of the RF chip SX1280, at 17mW. The IPEX1 generation antenna base is adopted, and the dipole T-type antenna is matched
There is no PA/LNA on the EP2 2400RX receiver, so its telemetry power is the same as that of the RF chip SX1280 at 17mW. With highly efficient pagoda ceramic antennas, they still maintain high acceptance sensitivity in a limited space due to the low latency and high refresh rate RF modules of the ELRS Nano receiver, they are ideal for FPV competitions and remote FPV. At the same time, these receivers have an ultra-light and ultra-small size