Speedybee F405 AIO Flight control 40A electric modmodel FPV barometer Bluetooth wireless tuning

FLIGHT CONTROLLER

• MCU: STM32F405

• Gyro: ICM-42688P

• USB Port Type: Type-C

• Barometer: SPA06-003

• OSD: Supported

• Bluetooth BLE: Supported, Bluetooth speed enhancement - 2.0

• Wireless Flight Controller Firmware Update: Supported (no need to press physical BOOT button)

• Wireless Download & BlackBox Analysis: Not supported

• DJI Air Unit Connection Method: Supports both 6-pin direct insertion and soldering

• 6-pin DJI Sky Port Direct Insertion: Supported, can directly connect to DJI O3/RunCam Link/Caddx Vista without changing wire order

• Flash (for BlackBox): 8MB

• Betaflight CC Pads (Camera Parameter Adjustment): Supported

• Input Voltage: 3S-6S LiPo battery

• 4V5 Output: Two 4V5 outputs; total current 1A

• 5V BEC Output: Three 5V outputs; total current 2A; shared with 4V5

• 9V BEC Output: None (comes with an external BEC module, can switch between 5V and 9V); total current output 2A

• MOTOR: M1-M4

• UART: 4 full-function serial ports (UART3, UART4, UART5, UART6 + SBUS[R2])

• ESC Telemetry: None

• I2C: Supported

• LED Pads: Supported, used to control WS2812 LED lights

• Buzzer Pads: Supported, BZ+ and BZ- pads

• BOOT Button: Supported, press and hold the BOOT button while powering on to enter DFU mode for firmware recovery

• RSSI Pads: None

• SmartPort: Not supported

• Supported Flight Controller Firmware: BetaFlight (Default), INAV

• Firmware Target Name: SPEEDYBEE F405AIO

• Mounting: 25.5 x 25.5mm, 2mm hole diameter

• Dimensions: 33.0mm (length) x 33.0mm (width) x 8mm (height)

• Weight: 13.6g (including CNC)

ESC

• Input Voltage: 3-6S LiPo battery

• Continuous Current: 40A

• Burst Current: 45A (10s)

• ESC Protocol: Supports DSHOT600/300; other protocols may cause severe errors, please use with caution.

• Output Voltage: VBAT battery voltage (used to power the flight controller)

• Current Sensor: Supported (Scale = 254, Offset = 0)

• Firmware: Bluejay JH-40 48kHz